search

Centurion G-SPEAK Manual de instalación Pagina 27

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 40
  • Tabla de contenidos
  • MARCADORES
    • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 26
page 24
Switch Phone Functionality
The GSM Controller has capacity for ten Switch Phone numbers in the case of the
G-SPEAK Classic, or 100 Switch Phone numbers in the case of the G-SPEAK Classic+,
each of which can activate one or more (in the case of the G-SPEAK Classic+) outputs
by Missed Call or SMS. Numbers are added using the AP command (see, List of
Commands). These numbers are not to be confused with the Voice numbers referred to
in the Voice Functionality section.
A user’s number can be programmed as both a Voice Phone and a Switch
Phone.
Voice Phone Switch Phone
Yes
DTMF (phone keypad during call)
No
Yes (Any Voice number subscribed
to system notification)
Yes (Any Voice number subscribed
to system notification)
Yes (G-SPEAK Classic+ only)
Yes (G-SPEAK Classic+ only)
Yes
No
Missed call, SMS
Yes (G-SPEAK Classic+
only)
No
No
No
No
No
Voice communication
with mobile
Switches outputs via
Receives notification of
input activation
Receives notification of
password reset
Receives notification of
firmware upgrade
Listen
Talk
Settings
Changing the Default Password
The G-SPEAK leaves the factory with a default password of 1234. The password is used
to prevent unauthorised users from changing settings, and adding new numbers. It is
recommended that the default password is changed (see List of Commands in this
section), and a record stored in a safe place.
The following command sets may be used to SMS the respective configuration
settings to the controller. The SMSs will need to be sent to the number of the
SIM card in the controller.
List of Commands (for SMS configuration and administration of the controller)
In the examples on the next page, ‘xxxx’ represents the Controller’s password(see
Changing the Default Password)
If the password is forgotten, it may be reset to 1234 by removing power from the unit,
bridging the inner pins of the bootloader header with a suitable terminal jumper, and
powering up. Remove the jumper, and wait for the LEDs to go off – an SMS will be sent
to the first Voice Phone learned into Button 1, indicating that the password has been
reset to 1234.
Resetting the Password to Default
Vista de pagina 26
1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 39 40

Comentarios a estos manuales

Sin comentarios
  • LogTag Recorders Beam-electrolux Serialio Skpad NICI
  • Kicker Altavoces del coche Savin Copiadoras Bose Auriculares para móvil Hughes & Kettner Altavoces barra de sonido Hoover Suelo Por Las Máquinas
  • Acer Aspire 5940G Viper Fang 28T Sharp R-212 DeDietrich Dishwasher Maytag MMV5156AAB
  • Vacuubrand CVC 3000 Manual de usuario Alesis Q25 Manual de usuario Philips 6423LC Manual de usuario Cub-cadet SLT1554 Manual de usuario Vodafone Smart 4 turbo Manual de usuario